| |
Network Video Technologies
Network Video Technologies develops and markets an award winning line of video transmitters/receivers and hub/power systems for the transport of data, low voltage power and audio.
NVT continues produce leading edge video transmission and power supply equipment featuring unsurpassed performance backed up by excellent customer support.
Founded in 1990, NVT is incorporated in the state of California, USA and has a stocking office in Menlo Park and Teddington England. All NVT products are UL, CE, WEEE, RoHS compliant and feature a limited lifetime warranty with an advanced replacement policy. NVT has a worldwide network of direct sales people, and representatives.
|
4005 Bohannon Drive
Menlo Park, CA 94025
(800) 959-9870
fax (650) 326-1940
www.nvt.com
Customer Service
Customer Service
(800) 959-9870
info@nvt.com
|
-
NETNV1662J

Passive 16-Channel Transceiver Hub
|
The NVT NV–1613A is a 16-port passive transceiver hub that allows transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire.
|
4.20 lbs (1.91 kg)
Hub Kit includes 16 2-foot (60cm) coax jumper cables & rackmount hardware
Supports "up-the coax" type P/T/Z control signals up to 750ft (225m)
Built-in transient protection
High-Density 19" 1U high enclosure features 16 ports
|
UTP is less expensive than coax and fiber
Easy Installation
Perfect for larger CCTV installations where port density and camera number growth are prevalent.
Allows video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits.
Baseband (composite) signals of any type are supported.
|
-
NETNV1662R

16-Channel Active Receiver DA Hub
|
The NV–1662R is a 16-channel active (amplified) distribution amplifier device that allows the transmission of real-time monochrome or color video on up to one mile (1,6km) using Category-2 or 3 Unshielded Twisted-Pair (UTP) or up to 1.5 miles (2,4km) NTSC using Category-5 or better.
|
Built-in sharpness and brightness controls; Green Active LED for each port
Built-in transient protection & ground lifting
Compatible with qualified OEM cameras
High-Density 19" 1U high enclosure for all four models
Available with screw terminal video inputs
|
Easy Installation
UTP has an unlimited bend radius
UTP is color coded
UTP is less expensive than coax and fiber
Limited lifetime warranty
|
-
NETNV214AM

Single Channel Passive Video Transceiver
|
The NVT Model NV-214A-M Video Transceiver is a passive (non-amplified) device that allows the transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire.
|
Features a 9 inch mini-coax pigtail
Supports "up-the-coax" type control signal up to 750 ft
Transmit up to 750 ft to another passive transceiver or up to 3000 ft to an active receiver
|
UTP is color coded
UTP has an unlimited bend radius
UTP and NVT is extremely easy to install
In many cases UTP is already installed
UTP is less expensive than coax and fiber
|
-
NETNV218APVD

Passive Power-Video-Data Video Transceiver
|
Use for integrating power, video and data onto 4-pair RJ45 cables.
|
Up to 3,000ft (1km) with an NVT active receiver or hub
Use with the RJ45 connector based NV704JPVD or the NV716JPVD for organized cable management to your c
Mini-coax pigtail supports in-camera mounting in most dome cameras
Power-Video-Data (PVD) signals are routed via UTP and RJ45 or "Press-Fit" terminal block for organized pass-through
Transmit up to 750 ft to another passive transceiver or up to 3000 ft to an active receiver
|
Built-in transient protection
Low emissions
Interference rejection
|
-
NETNV3213A

Passive 32-Channel Transceiver Hub
|
The NVT NV–3213A is a 32-port passive transceiver hub that allows transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone wire.
|
High-Density 19" 1U high enclosure features 32 ports
Built-in transient protection
6.6 lbs (3.0 kg)
17 in wide, 1.7 in high, 8.125 in deep (43 cm wide, 4.5 cm high, 20 cm deep)
DC to 5 Mhz
|
UTP is less expensive than coax and fiber
Easy Installation
Compatible with qualified OEM cameras
No power required
Supports "up-the coax" type P/T/Z control signals up to 750ft (225m)
|
|